oh my gosh I have a sharp xe-406 and it is showing REG 0.00 and I cant it to do any without the alarm going off

Hello and welcome to ExpertHelp.com! My name is Byron Narciso and I'm going to do everything in my power to answer your question to your full satisfaction!

Before we get started, I want to remind you ExpertHelp.com is an independent professional support company. We are not associated with Sharp nor are we paid to provide support on their behalf. However, we have helped hundreds of customers with similar questions and believe we can help you too. OK, let’s get started! :)

I’m available to chat now. Please let me know that you are ready by posting a response. I’ll leave my chat session open for the next 15 minutes or so and wait for your reply. If I don’t catch you this time, please respond with a few times (including your timezone) that work best for you and we can connect then.

Hello Cindy  

Try  pressing "CL" to clear the error. If it doesnt clear the error , try pressing "ESC"twice. 

Let me know if it works. 

Did you try to restart it by turning it off and try to initialize the XE 406 again? 

May I know the status? 

If it still doesnt work  Press the numeric 1 then CLK # and let me know if it works.

I apologize I won't be able to offer you the most helpful answer on this issue. I have escalated your question so that it will be taken care of an  another expert who can assist on Sharp. We appreciate your patience. You will be notified via email when a new Expert contacts you for continued support for your issue.

Thank you. 

Hello and welcome to ExpertHelp.com! My name is Abe Pastor and I'm going to do everything in my power to answer your question to your full satisfaction!

Before we get started, I want to remind you ExpertHelp.com is an independent professional support company. We are not associated with Sharp nor are we paid to provide support on their behalf. However, we have helped hundreds of customers with similar questions and believe we can help you too. OK, let’s get started! :)

I’m available to chat now. Please let me know that you are ready by posting a response. I’ll leave my chat session open for the next 15 minutes or so and wait for your reply. If I don’t catch you this time, please respond with a few times (including your timezone) that work best for you and we can connect then.

Looking at the situation the beep/alarm happens when you do something to the printer like pressing a key. If it happens when you press buttons, try this: If you press clear (CL) and press some of the numeric buttons, you should see numbers appear on the display. If you can get numbers but just a beep when you press a department key, then you are not logged in.  Try to log in again using your secret code/clerk code before starting any entries. Just set the mode switch to the REG position, enter the clerk code and press CLK#. Let me know if it helps by replying to this message. Thanks